New amorphous silicon solar panel buy in Buffalo, Baton Rouge, Oxnard

First electronic optical fibers with hydrogenated amorphous silicon are developed

01.01.70

Badding explained that hydrogenated amorphous silicon -- a noncrystalline form of silicon -- is ideal for applications such as solar cells. Hydrogenated amorphous silicon also would be useful for the light-guiding cores of optical fibers; however, depositing the silicon compound into an optical fiber -- which is thinner than the width of a human hair -- presents a challenge. "Traditionally, hydrogenated amorphous silicon is created using an expensive laboratory device known as a plasma reactor," Badding explained. "Such a reactor begins with a precursor called silane -- a silicon-hydrogen compound. Our goal was not only to find a simpler way to create hydrogenated amorphous silicon using silane, but also to use it in the development of an optical fiber."

Because traditional, low-pressure chemistry techniques cannot be used for depositing hydrogenated amorphous silicon into a fiber, the team had to find another approach. "While the low-pressure plasma reactor technique works well enough for depositing hydrogenated amorphous silicon onto a surface to make solar cells, it does not allow the silane precursor molecules to be pushed into the long, thin holes in an optical fiber," said Pier J. A. Sazio of the University of Southampton in the United Kingdom and one of the team's leaders. "The trick was to develop a high-pressure technique that could force the molecules of silane all the way down into the fiber and then also convert them to amorphous hydrogenated silicon. The high-pressure chemistry technique is unique in allowing the silane to decompose into the useful hydrogenated form of amorphous silicon, rather than the much less-useful non-hydrogenated form that otherwise would form without a plasma reactor. Using pressure in this way is very practical because the optical fibers are so small.

Source: Science Daily (press release)

amorphous silicon solar panel - News

SNEC PV 2011: Rofin PowerLine L 400 for Processing of Thin-Film Solar Modules

Solar Novus Today - Feb 14, 2011

for edge ablation of thin-film layers in the production of amorphous silicon (a-Si)/micro silicon (µ-Si), cadmium-telluride (CdTe) and CIS solar cells.

When to use a pyranometer vs a reference cell

PennEnergy- Energy News (press release) - Feb 14, 2011

The pyranometer gives an independent, accurate reading of the total available solar radiation. Depending on the technology (amorphous silicon,

New Research Results in Solar Cells with Increased Grain Size

AZoCleantech - Feb 14, 2011

Also, the new method requires only between 100 to 300°C temperature to make the amorphous silicon to attain the poly-silicon state instead of the 1000°C

Solar Simulators Webcast with Konica Minolta

RenewableEnergyWorld.com - Feb 14, 2011

Would you set up a solar simulator with a crystalline silicon reference cell, then use it for amorphous silicon cell testing?

New Crystallization Method to Create Poly-Silicon for Low Cost Solar Power

Azom.com - Feb 09, 2011

Many commercialized solar cells incorporate amorphous silicon and poly-silicon, which have acceptable conversion efficiency and cost much less than